Cisco Headset 500 Series Manual page 15

Accessories
• Cisco Headset 560 Series: Connect the standard base or multibase with the USB or Y-cable.
Procedure
Step 1
On the phone, press Applications
Step 2 Select Accessories > Setup > Reset settings.
Step 3
At the warning window, select Reset.
Adjust the Headset Feedback
When you use a headset, you can hear your own voice in the earpiece, which is called headset sidetone or
headset feedback. You can control the amount of headset sidetone on your phone.
Procedure
Step 1 Press Applications
Step 2
Select Settings > Headset sidetone.
Step 3 Select a setting.
Set Up a Wideband Standard Headset
You can use a headset that supports wideband audio. Wideband audio improves the quality of the sound you
hear in the headset.
Procedure
Step 1 Press Applications
Step 2
Select Accessories > Analog headset > Setup.
Step 3 Press On or Off to enable or disable wideband for the analog headset.
Step 4
Press Return .
Enable Electronic Hookswitch Control on Your Phone
If your administrator has enabled Admin settings on your Cisco IP Phone, you can enable or disable electronic
hookswitch control to connect with a Cisco Headset 560 Series base. Electronic hookswitch control is enabled
by default.
Note This feature is available on Cisco IP Phone Firmware Release 12.7(1) and later.
.
.
.
Adjust the Headset Feedback
Accessories
15