Replace the Staple Cartridge of the Saddle Stitch Unit
Introduction
If a staple cartridge of the saddle stitch unit of the optional Saddle Finisher-AF2 is almost empty,
the control panel will display a message indicating which staple cartridge must be replaced. The
procedure below describes how to replace the staple cartridge.
NOTE
This procedure is only necessary when the Saddle Finisher-AF2 is attached.
Required tools
Staple P1
Procedure
Replace the staple cartridge of the saddle stitch unit
Step
Action
1
Open the front door of the stacker/stapler.
2
Pull out the saddle stitch unit.
3
Grab the tab of the staple case and pull
the staple case out of the staple unit.
4
Hold the cover of the staple case by its
left and right sides
Lift the cover and slide the cover off.
Canon varioPRINT DP line
Replace the Staple Cartridge of the Saddle Stitch Unit
Illustration
Chapter 14 - Maintain the print system
4
429