Replacing The Staple Cartridge In The Saddle Stitcher Unit - Canon imagePRESS C7011VPS series Operation Manual

Replacing the staple cartridge in the saddle stitcher unit

Introduction
This section describes how to replace the staple cartridge of the saddle stitcher.
IMPORTANT
• Take care when handling the optional equipment that is attached to the machine. When an
optional unit's cover is opened to replace a staple cartridge, discard punch waste, or clear
paper or staple jams, prints may still be output if other optional units are operating normally,
and are not involved in the paper or staple jam removal procedure.
• If necessary, remove all of the output paper in the booklet tray before replacing the staple
cartridge in the saddle stitcher unit.
NOTE
• This procedure is necessary only if the optional Saddle Finisher-AJ2 is attached.
• Since both the front and inner staple cartridges need to be replaced when staples run out in
the saddle stitcher unit, we recommend that you order staple cartridges from your local
authorized dealer before your stock runs out.
Procedure
1.
Open the front cover of the finisher.
2.
Pull out the saddle stitcher unit (F-C4).
3.
Pull out the staple case, holding it by its tab.
Replacing the staple cartridge in the saddle stitcher unit
Chapter 13 - Add toner and staples 337