Wiring Diagram - Makita BO5030 Technical Information

W
iring diagram
Fig. D-2
BO5030 (Specifications with Terminal block)
Fix lead wires (black)
to Brush holders with
these Lead wire holders.
Route one of Lead wire
(black or brown) of
Power supply cord
through this groove and
connect the lead wire
with Switch terminal.
Brush holder
Terminal block
(Insert it between
ribs as illustrated.)
Put the slack portion of Lead wires
(red, white) in the space here.
Insulated connector
(Install it between two
ribs and pin as illustrated.
pin
Note: Some specifications do not have Noise suppressor.
Fix lead wires (red) for Switch
with these Lead wire holders.
BO5030 (Specifications with Insulated connector
instead of Terminal block)
Put the slack portion of Lead wires
(red, white) in the space here.
Switch
Fix Lead wires (white) of Noise
suppressor with these Lead wire holders.
Brush holder
Noise suppressor
P 6/ 7
ribs