Internet Explorer Settings; Changing The Pc's Ip Address - Honeywell ADPRO iFT Series Quick Setup Manual

ADPRO iFT Series Quick Setup Guide
Note
Webserver is disabled by default starting with ADPROXO 4.5. It can only be reenabled by a
technician on a system in which an admin user has enabled the technical grant. To install the client
software using the XO device's web page, the webserver must be enabled by the technician which is
a security risk. You can get the client software from the release DVD or from the support site
(www.xtralissecurity.com).
5.2.1

Internet Explorer Settings

Note
The preferred browser for installing the XO client software is Internet Explorer. If you cannot use
Internet Explorer, try any other internet browser. In this case, you have to install the MeadCo Neptune
plugin. You can download the plugin from www.meadco.com/Neptune/Download.
When installing the XO client software via the XO device's web page, you need to add the XO device's IP
address to your Trusted sites in Internet Explorer. The XO device's default IP address is 10.0.0.10 with subnet
mask 255.255.255.0. Proceed as follows:
1. In Internet Explorer, choose Tools > Internet options.
2. Click the Security tab.
3. In the Select a zone... box, click Trusted sites, and then click Sites.
4. In the Add this website... box, type http:// followed by the XO device's IP address. For example:
http://10.0.0.10
5. Click Add, and then click Close.
6. Click OK to close the Internet Options window.
If installation is still not possible, you may try clearing the Enable Protected Mode checkbox in the Security
tab.
Caution!
Check with the IT department if you are allowed to switch off protected mode, because it may lead to
IT issues.
5.2.2

Changing the PC's IP Address

The XO device's default IP address is 10.0.0.10 with subnet mask 255.255.255.0. If you install the client
software via the device's web page, or if you want to configure a device using the XO client, you need to put your
PC in the same IP range (for example, IP address 10.0.0.2 with subnet mask 255.255.255.0).
To change the PC's IP address in Windows 10, proceed as follows:
1. Click Start, and then click Control Panel (View by: Category).
2. Click Network and Internet.
3. Click Network and Sharing Center.
4. Click Connections.
5. Click Properties.
6. Click Internet Protocol Version 4 (TCP/IPv4).
7. For ease of initial setup, change the PC's TCP/IP settings to the following:
IP address
Subnet mask
8. Click OK to return to the Local Area Connection window.
8
10.0.0.2
255.255.255.0
ADPRO
27929_07