Controlling The Hometronic With The Remote Control - Honeywell Hometronic HRD 20 Operation

Controlling the Hometronic with the remote control

After the buttons have been assigned you use the remote control to

control the Hometronic. Observe the following principle:

In order to select a component or a Lifestyle, press one of the selection

buttons 1-6, A or B: The LED lights up green.

In order to control a component, press the control buttons ▼/▲ or

confirm the Lifestyle by pressing the OK button: The LED flashes and

then displays green again.

The selected component remains active until the LED extinguishes

(approx. 15 seconds) or another component is selected.

Note: If the Hometronic is operating in automatic mode, the changes with

the remote control may only be retained until the next switching point.

Example button assignment

The following explanation assumes that the buttons have a typical

assignment:

Button 1

Control the ceiling lamp in the living room

Button 2

Control the shutters of the living room

Button 3

Control the setpoint temperature of the living room

Button 4

Activate the "Evening" Lifestyle

Table of Contents