Advertisement
3.3 CONFIGURING ADVANCED SETTINGS
The advanced settings mode can be used to adapt the
12
rotating watch winder to specific situations (e.g. the
watch not being detected due to a special strap or
bracelet, insufficient torque to drive the winder, torque
limit too low, etc.). To access this mode, click on the
advanced settings tab and enter the password: 9876.
The current settings for the winder are shown in the
appropriate fields. It is recommended to write down
these factory settings on paper so as not to lose them
before making any changes. In the same way as for
standard settings, changes are sent to the rotating
winder by using the "Update" button. They are only
saved once the interface has been disconnected. If
the winder is turned off manually (using the ON/OFF
button) the changes will not be saved.
MAC APPLICATION
WINDOWS APPLICATION
Monitoring
The "Monitoring" field allows continuous checking of
certain settings read by the rotating winder. "Motor cur-
rent" indicates the motor current during 2 clockwise and
anti-clockwise rotations. "Position Sensor" indicates the
position of the moving part of the winder. "IR Sensor"
relates to the watch-detection sensor, indicating the
presence or absence of the watch.
Motor Torque
This setting adjusts the motor torque by acting on the
motor's PWM. This value can be configured between 30
(minimum value) and 100 (maximum value). The higher
the value, the more torque the motor will have, but the
more power it will use. If the rotating winder has diffi-
culty turning (heavy watch, etc.), the torque setting can
be increased. To do this, press "Update" and disconnect
the winder in order to check if the increase is sufficient.
Motor Protection
This setting shows the level of current above which the
motor goes into auto-protection. Do not change this
factory setting – it can indicate if the motor is damaged.
Detection Threshold
This final setting is used to alter the level at which the
watch is detected in the rotating winder. If the sensor
does not detect the watch, this setting can be lowe-
red. Select "Monitoring" then "IR Sensor", place the
watch in the winder and read the value shown. Then
13
Advertisement
