Cisco 6160 Installation Procedures Manual page 22

Installation Procedures
4.2.11 Connect the NI-2 Card to the Network
This section provides installation procedures for the following network connections:
•
•
•
Cisco recommends that you label each data cable at both ends to identify its destination.
Tip
Cisco does not provide the cables for the network connections. See
Note
4.2.11.1 DS3 Network Connections
Complete the following steps to connect the DS3 network connections:
Verify that the DS3/2DS3 or DS3+T1/E1 IMA NI-2 card is installed in slot 10 (or slot 11, if a secondary
Step 1
NI-2 card is being installed for redundancy) of the Cisco 6160 chassis to ensure that the DS3 NI-2 card
connections are active.
Note
Step 2 Attach one end of a coaxial cable to the TX BNC connector for DS3 Port 1 on the I/O card.
Note
Step 3 Attach the end of the cable that you used in
Attach one end of a coaxial cable to the RX BNC connector for DS3 Port 1 on the I/O card.
Step 4
Attach the end of the cable that you used in
Step 5
Reboot the system to reassociate the system MAC address.
Step 6
Repeat
Step 7
Cisco 6160 Hardware Installation Guide
4-22
DS3 Network Connections, page 4-22
OC-3c Network Connections, page 4-23
T1 or T1 IMA Network Connections, page 4-23
See the "Redundancy in Subtended Configurations" section on page 1-42
about redundancy configurations.
See Table 2-4 for cable specifications. See
locations.
Step 1 through Step 6 for each Cisco 6160 chassis being installed.
Chapter 4 Installing a Cisco 6160 Without a POTS Splitter Configuration
Table 2-4
Figure 1-19 or Figure 1-23
Step 2 to the ATM switch.
Step 4 to the ATM switch.
for cable specifications.
for more information
for DS3 port connector
OL-2190-02 B0