Cisco 6160 Installation Procedures Manual page 20

Installation Procedures
To establish APS link redundancy repeat
Step 4
Repeat
Step 5
4.2.10.3 T1 or T1 IMA Subtending Connections
Complete the following steps to connect the TI or TI IMA subtending connections:
For more information about T1 or T1 IMA subtending connections, see the
Note
Configuration with DS3+T1/E1 IMA NI-2 Cards" section on page
Verify that the DS3+T1/E1 IMA NI-2 card is installed in slot 10 (or slot 11, if a secondary NI-2 card is
Step 1
installed for redundancy) and the DS3/2DS3+8xT1 IMA I/O card is installed on the chassis backplane.
Note
Connect one end of an RJ-48 cable to one of the RJ-48c receptacles on the DS3/2DS3+8xT1 IMA I/O
Step 2
card located on the subtending host chassis backplane.
Figure 4-12
Note
Cisco 6160 Hardware Installation Guide
4-20
Step 1 through Step 4 for each subtending host chassis.
See the "Redundancy in Subtended Configurations" section on page 1-42
about redundant configurations.
shows the cabling for a T1 or T1 IMA subtended network configuration.
See Table 2-4 for cable specifications. See
Chapter 4 Installing a Cisco 6160 Without a POTS Splitter Configuration
Step 2 and Step 3 for a secondary OC-3c/OC-3c NI-2 card.
1-7.
Figure 1-19 for T1 interface locations.
"Subtended Network
for more information
OL-2190-02 B0