Replacing the auxiliary cooling fan of the drive module (frames R6 to
■
R9)
WARNING!
Obey the safety instructions of the drive. If you ignore them, injury or death,
or damage to the equipment can occur.
1. Stop the drive and do the steps in section
you start the work.
2. Unplug the power supply wires from the control unit terminal X208:FAN2.
3. Lift the fan up.
4. Install the new fan in reverse order. Make sure that the arrow on the fan points up.
5. Reset the counter (if used) in group 5 in the primary control program.
2
3
2
Electrical safety precautions (page 18)
Maintenance 169
before