Data Transmission In Normal Mode - Honeywell 032211.17 Manual

28
Ÿ Register sensors
After activating the teaching mode
are automatically registered.
The indications off-mode sensor LEDs indicate when registrati-
on is completed. If an LED of an occupied sensor is still lit up or
flashes, this indicates a fault or a triggering of the corresponding
sensor (see following table).
Such sensors are stored as
teaching mode!
LED lights up LED flashes
Totalling Teaching Sensor
LED LED LED 1-4
off-mode
1)
Check installation! (e.g. the distance to the mounting surface of metal, distance transmission unit
Chapter 6.1 in these instructions as well as the mounting and connection instructions of the relevant sensor.)
Ÿ Exit teaching mode
Do not exit the teaching mode, until the
Switching to normal operating state:
1.) Switch S1/8 to "OFF" .
2.) The EU now checks for approx.
the sensor code is permanently stored.
3.) After checking, the relevant sensor LED lights up for approx. 1 second if a sensor malfunctions or if no sensor is available. If the
LED of an occupied sensor lights up, repeat the teaching mode.
4.) The teaching mode is then automatically exited.
The LED "Teaching mode" (yellow) goes out. The EU is now in indication mode (normal mode).
If necessary, set the address and BUS system according to the application. Disconnect the operating voltage briefly after changing
the setting
Place cover in position
Alarm and tamper transmission is automatically stopped. If connected to the control panel, the tamper alarm remains stored until it is
cleared.

7.8.4 Data transmission in normal mode

Sensors, that were stored on exiting the teaching mode as "NOK" (not occupied or evaluated as NOK), will be handled accordingly
depending on the operating mode:
- BUS-1 in 5 address mode and BUS-2:
- BUS-1 in 1 address mode:
Attention!
This differs from the previous version EU BUS-1 in 5 address mode. Transmission in these cases was OK.
, all connected sensors
not available on exiting the
Does not apply
Sensor Function
LED 5
Teaching mode active, all sensors available and ready to funciton
off-mode
If a sensor LED lights up
- the sensor is not occupied
- or it is beyond the transmission range
- or it is defect
- or it has already triggered.
When the LED allocated to the sensor
sensor is critical
No sensor connected or the end of line resistor is outisde the tolerance
LEDs of all required sensors are in off-mode
1 second that the data transmission of the sensors is functioning correctly. If evaluation is "OK",
Transmission to the control panel "NOK" (triggered)
No transmission to the control panel
Mounting and Connection Instructions IDENTLOC Evaluation Unit
LED
totalling
indicator
LED
Teaching mode
BUS-2 BUS-1
S2
LM NM
S1
Address
ON
1)
flashes
1)
.
LED
Sensor 1
LED
Sensor 2
LED
Sensor 3
LED
Sensor 4
LED
Sensor 5
, the transmission state of the
®
sensor etc., see