Page 1
Zip ChillTap and Wall Fountain ® Under-counter chiller and wall-recessed chilled water systems Model: CH103 Under-counter chiller Model: CH104 Wall-recessed chiller Affix model number label here Page 1 of 12 Zip CH103, CH104 - Installation & operating instructions - 82127UK - June 2015 v1.04...
Repairs must only be carried out by Zip Heaters (UK) Ltd or an authorised Zip service engineer. If the power supply cable is damaged it must be replaced by a Zip service engineer or a qualified electrician.
The products are listed under the WRAS (Water Regulations Advisory Scheme) Water Fittings and Materials Directory. Zip Heaters (UK) Ltd cannot be held liable for any damages caused by failure to observe these instructions. Leave these instructions with the end user after installation.
This appliance must be earthed. DO NOT turn the electricity supply on until the system has been purged. (See Commissioning, page 9). Page 4 of 12 Zip CH103, CH104 - Installation & operating instructions - 82127UK - June 2015 v1.04...
Connect the red tube from the tap to the push fit fitting marked INLET on the top right rear of the chiller unit, trim to length before fitting. Page 5 of 12 Zip CH103, CH104 - Installation & operating instructions - 82127UK - June 2015 v1.04...
Cut pipes should not be overly long, but must allow sufficient length to avoid stress at connection points. Page 6 of 12 Zip CH103, CH104 - Installation & operating instructions - 82127UK - June 2015 v1.04...
Zip Wall Fountain should only be installed by a competent installer in accordance with local water authority by-laws and these instructions. Zip Wall Fountain is designed to be recess mounted within a wall. The bottom should sit on a supporting flat and level plinth at least 100mm above finished floor level.
Page 8
(under the sink bowl), and tighten the nut to secure the tap firmly into place. Connecting the system together Use the same procedure as CH103 (see CH103 ChillTap installlation ® instructions page 5). Page 8 of 12 Zip CH103, CH104 - Installation & operating instructions - 82127UK - June 2015 v1.04...
Rotate Use only a Zip filter to match the one used in your chiller product (see Spare parts and accessories page 3). The filter cartridge can be obtained through plumbing suppliers or direct from Zip. The filter is located behind the front Insert filter access panel on the CH104.
Call Zip, a qualified electrician or plumber for assistance, service, spare parts, or enquiries. Zip customer service 0845 6 005 005, 0345 6 005 005. Page 10 of 12 Zip CH103, CH104 - Installation & operating instructions - 82127UK - June 2015 v1.04...
Furthermore, this warranty does not displace any statutory warranty, but, to the extent to which Zip is entitled to do so, the liability of Zip under any statutory warranty will be limited at Zip’s option to the replacement of the appliance...
Registering your Zip installation on the Zip website may help to establish date of installation should it become necessary to service the appliance under terms of the Zip warranty. Page 12 of 12 Zip CH103, CH104 - Installation & operating instructions - 82127UK - June 2015 v1.04...