Advertisement
-Reinstall Motor-
1. Plug the new motor into the main power board.
2. Attach the green ground wire to the screw hole directly right of the tensioning screw.
3. Insert the Phillips motor mounting screws and hand tighten. You may need to use the offset
ratchet to get the screws in far enough. (Do not completely tighten so motor tension can be
adjusted.)
4. Tighten the motor tension screw to the same gap measured before disassembly. Before
tightening apply locktite to the screw (finger nail polish can be substituted for locktite.)
5. Tighten the two Phillps motor mounting screws completely.
6. Reinstall the case.
If you have any questions or concerns, please email
support@baratza.com
or call at 425-641-1245.
6
Advertisement
