The Honeywell Enraf Prover Series - Honeywell Enraf Operation Manual

Part No.: 44200004 - Revision 2

THE HONEYWELL ENRAF PROVER SERIES

Safety instructions for installation, commissioning, operation
and maintenance
Preface
The Honeywell Enraf (HE) SVP (Small Volume Prover) is a high precision
instrument for verification of calibration of flow metering equipment. The
SVP Controller and the Fusion4 Local Access Device (LAD) form the
control aspects of the SVP. The LAD is a hand held controller used to
interface to the SVP Controller allowing tasks such as the adjustment of
parameters, resetting of alarms and calibration. The LAD facilitates two way
data communications between the SVP Controller and the LAD, allowing
the rapid transfer of transaction data, configuration files and calibration
records and even upgrading of firmware in the field. The following warnings
apply to all components of the SVP.
Warning
Only use the instrument for its intended purpose.
EC declaration of conformity
Refer to the EC declaration of conformity and ATEX certificate(s), shipped
with the instrument.
Installation
The mechanical and electrical installation shall only be carried out by
trained personnel with knowledge of the requirements for installation of
explosion proof equipment in (potentially) explosive atmospheres.
The entire installation procedure shall be carried out in accordance with
national, local and company regulations. The entire electrical installation
shall be carried out in accordance with the International Standard
EN 60079-14 for electrical equipment to be installed in (potentially)
explosive atmospheres.
No specific installation requirements apply to the LAD; the device is
factory ready for connection to Fusion4 parent devices (for example the
SVP Controller).
SVP Controller Operation Manual vii