Connecting To Honeywell Genus Network; Icon Controller Identification On Genus Network; Network Logging-On Procedure - Honeywell ICON 100 SERIES User Manual

8. CONNECTING TO HONEYWELL GENUS
The Icon controller has an optional Genus
ICON-COMMS) which allows logging onto a Genus
monitoring and defrost control.
8.1. Icon Controller Identification on Genus
Icon has to be given a name (alias) in order to log onto the network. The following
naming convention is required for Genus
capabilities.
The Icon controller name is displayed as 'ICXX-Y' on Genus
is the STUB number and 'Y' is the CASE number.
Example of Stub number
(0...99) Parameter 27
1. Power down controller.
2. Connect network cable to Genus
®
3. Insert Genus comms module into the Genus
the Icon controller.
4. Power up controller.
5. After controller power up procedure (5 secs.) enter parameter configuration
setting mode (see section 5.8). Note: Key pad may need to be unlocked
(Depress UP and DOWN keys for 10 seconds until you see 'Pon'
displayed).
6. Scroll to parameter d27 and enter stub number 'XX' e.g. 13
7. Press SET key, the stub number will blink for 5 secs. Icon will then
automatically go to parameter d28 - (case parameter).
8. Enter case number 'Y' e.g. 4
9. Press SET key, the case number will blink for 5 secs. Icon will then
automatically go to d29 – (Genus
10. Scroll value to 1 and press SET key which will blink for 5 secs. (Note that if
Value=0 then Icon controller is not linked to Genus
11. Wait for Icon to time-out of parameter setting mode (20 secs)
12. Icon will now automatically log-on to Genus
Supervisor)
13. Controller alias will be visible on front-end within 2 minutes.
14. Refer to your front-end literature for further information regarding accessing
®
Icon via Genus network.
*1: A stub number (XX) represents the refrigeration section where the Icon controller is
situated within the supermarket.
*2: A case number (Y) represents the case within the stub. Also note that the case
representing "K" is displayed as ' :- ' on the Icon display
17
ICON 100 SERIES USER GUIDE
®
communication module (Part Number:
®
network for remote alarm
®
network identification and defrost
®
network. Where 'XX'
Example of Case Number
*1
(0...9, A...U) Parameter 28
Fig. 6. Icon identification on Genus

8.2. Network Logging-On Procedure

®
comms module.
®
comms socket at the rear of
®
enable / disable parameter).
®
system).
®
front end (PCVisor /
EN2B-0002UK07 R0404
NETWORK
®
Network
®
*2
®
Network