Part Mode - Yamaha MU50 Owner's Manual

This determines the fine tuning of the Part's Voice.
HINT
Detune could be used to slightly detune a Voice compared to the tuning of the rest of the
Voices for a richer sound. It could also be used to detune two different Voices being played
in unison. For example if two different Parts are set to the same MIDI channel (see page 36)
and same Voice, a naturally thick chorusing effect can be obtained by slightly detuning each
Voice in opposite directions here.

Part Mode

Selected Part and MIDI channel
Height of bars indicates selected Part Mode setting for each Part. (A
single bar indicates "normal" setting.)
(When Sound Module mode is set to C/M or DOC, Part 10 is set to
drumS1.)
This determines the mode for the Part. A setting of normal allows selec-
tion of the normal instrument Voices. (See the SOUND LIST & MIDI
DATA booklet.) The drum setting allows selection of the drum kits. (See
the SOUND LIST & MIDI DATA booklet.) The drumS1, drumS2 set-
tings are locations for storing specially programmed drum setups. These
setups can be edited by using the Drum Setup controls in the Multi Edit
mode. (See page 61.) The drum and drumS1, drumS2 settings are not
available in the Performance mode.
The Part Mode settings differ depending on the Sound Module mode
selected, as described below.
For XG XG mode: XG XG XG
All settings described above are available. When normal is selected,
any of the basic or the extended set of Voices can be used for the Part.
MULTI MODE
53