AEG MTE 350 Operation And Installation page 34

Installation
10.2 Installation options
10.2.1 Undersink installation
Non-pressurised, with non-pressurised tap
Pressure-tested, with pressure-tested tap
34
Appliance installation
Note
» Mount the appliance on the wall.
The wall must have a sufficient load-bearing capac-
ity.

» Undo the cover fixing screws by two turns.
» Undo the snap fastener using a screwdriver.
» Remove the appliance cover with the heater towards
the front.
» Using pliers, break out the knock-out for the power
cable in the appliance cover. Correct the contours
with a file if necessary.

