Troubleshooting; Installation; Safety - AEG MTE 350 Operation And Installation

Operation - Installation
6.

Troubleshooting

Problem Cause
The appliance will not No power to the ap-
start despite the DHW pliance.
valve being fully open.
The aerator in the tap
is scaled up or dirty.
The water supply has
been interrupted.
The required tem- The maximum tem-
perature is not being perature set inside the
reached. appliance is too low.
The appliance is at its
output limit.
If you cannot remedy the fault, notify your qualified con-
tractor. To facilitate and speed up your enquiry, please
provide the serial number from the type plate (000000 /
0000-00000).
MTE . . .
Model:
0000-00000
F-Nr:
32
Remedy
Check the fuses/
MCBs in your fuse
box.
Clean and/or descale
the aerator or replace
the special aerator.
Vent the appliance
and the cold water
inlet line (see chapter
"Settings").
Have your qualified
contractor adjust the
maximum tempera-
ture.
Reduce the flow rate.
000000
E-Nr:

INSTALLATION

7.

Safety

Only a qualified contractor should carry out installation,
commissioning, maintenance and repair of the appliance.
7.1 General safety instructions
We guarantee trouble-free function and operational relia-
bility only if original accessories and spare parts intended
for the appliance are used.
Material losses
!
Observe the max. permissible inlet temperature.
Higher temperatures may damage the appliance. You
can limit the inlet temperature by means of a central
thermostatic valve.
WARNING Electrocution
This appliance contains capacitors which are dis-
charged when disconnected from the power supply.
The capacitor discharge voltage may briefly reach
> 34 V DC.
7.2 Instructions, standards and regulations
Note
Observe all applicable national and regional regula-
tions and instructions.