Manual Preset Tuning - Yamaha EMX-120CD Owner's Manual

TUNING OPERATION
CD CHANGER RECEIVER EMX–120CD
PROGRAM
STANDBY/ON
MUSIC
ECHO ECHO
KARAOKE MEMORY
PHONES
DISPLAY MEMORY AUTO/MAN'L
TIME ADJ TIMER
2, 5
CD
1 2
4, 2 2
1 2
6 7
6 7
A B
TIME PROG
MODE
DISC SKIP
CD TUNER
CENTER/REAR
TEST
/DELAY
ECHO
LEVEL
STANDBY/ON
SLEEP
VOLUME
3, 1 1
A/B/C/D/E PRESET/TUNING/BAND
DISC
OPEN/CLOSE CHANGE
1 2 3
DISC DISC DISC
VOLUME
INPUT SELECTOR
CD TUNER
VCR•LD/TV•CD•TAPE/MD•TUNER
MIC TONE MIC MIC MIXING
REPEAT TIME INPUT TRIM
HOUR MIN
NORMAL SOFT MIN MAX
4, 2 2
TUNER
3 4 5
3 4 5
8 PRESET
8 9 0
3, 1 1
C D E
+
I0
REPEAT RANDOM OPEN/CLOSE
STOP PLAY/PAUSE
INPUT
FLAT
KARAOKE MUSIC PROGRAM
DISPLAY

Manual preset tuning

This unit can store station frequencies selected by tuning
operation. With this function, you can select any desired
station only by calling the corresponding preset station
number. Up to 40 stations (8 stations x 5 groups) can be
stored.
To store stations
(Example: To store a station to A1)
1
Tune in to a desired station.
(Refer to the previous page for tuning procedure.)
2
Press the tuner MEMORY button.
* "MEMORY" and "PRESET" will flash on the display for
about 5 seconds.
3
Select a desired group (A – E) of preset stations by
pressing the A/B/C/D/E button confirming it on the
display, before "MEMORY" goes out.
(In this case, select group A.)
4
Select a preset station number by pressing the
button repeatedly before "MEMORY" goes out.
(In this case, select "1".)
5
Within about 5 seconds, press the tuner MEMORY button
again.
The currently displayed station
has been programmed to A1.
* In the same way, program other stations to A2, A3 ... A8.
* You can program more stations to the preset station
numbers of other groups in the same way by selecting
other groups in step 3.
To recall a preset station
1 1
Select a group of preset stations by pressing the
A/B/C/D/E button.
2 2
Select the desired preset station number by pressing the
or button repeatedly.
Notes
•
A new setting can be programmed in place of the former
one.
•
For presets the setting of the AUTO/MAN'L button is
stored along with the station frequency.
For easier operation
By using the preset station number buttons and the
A,B,C,D,E selector buttons on the remote control transmitter,
a preset station number and a group can be selected directly.
E-27
AUTO
MHz
or