Tuning Operation; Automatic Tuning - Yamaha EMX-120CD Owner's Manual

TUNING OPERATION

CD CHANGER RECEIVER EMX–120CD
PROGRAM
STANDBY/ON
ECHO MUSIC ECHO
KARAOKE MEMORY
PHONES
DISPLAY MEMORY AUTO/MAN'L
TIME ADJ
3,
CD
1 2
1 2
6 7
6 7
A B
TIME PROG
MODE
1
DISC SKIP
CD TUNER
CENTER/REAR
TEST
/DELAY
ECHO
LEVEL
SLEEP
1 2
A/B/C/D/E PRESET/TUNING/BAND
DISC
OPEN/CLOSE CHANGE
1 2 3
DISC DISC DISC
INPUT SELECTOR VOLUME
CD TUNER
VCR•LD/TV•CD•TAPE/MD•TUNER
MIC TONE MIC MIC MIXING
REPEAT TIME INPUT TRIM
TIMER HOUR MIN
NORMAL SOFT MIN
2 2 4,
TUNER
3 4 5
3 4 5
8 PRESET
8 9 0
C D E
+
I0
REPEAT RANDOM OPEN/CLOSE
STOP PLAY/PAUSE
INPUT
FLAT
KARAOKE MUSIC PROGRAM
STANDBY/ON
DISPLAY
VOLUME
Normally, if station signals are strong and there is no
interference, quick automatic-search tuning (Automatic
tuning) is possible. However, if signals of the station you
want to select are weak, you must tune to it manually
(Manual tuning).

Automatic tuning

1
Select the tuner by pressing the TUNER INPUT
SELECTOR button so that "TUNER" appears on the
display.
2
Select the reception band (FM or AM) by pressing the
PRESET/TUNING/BAND button confirming it on the
display.
* Do not select a preset tuning mode (in which
MAX
"PRESET" lights up on the display.)
3
Press the AUTO/MAN'L button so that "AUTO" lights up
on the display.
(In this mode, stations are received in stereo or monaural
automatically.)
3 3
4
Press the
press the
(When tuned in to a station, "TUNED" will light up on the
display.)
5
If the station where tuning search stopped is not the
desired one, follow step 4 again.
* If the tuning search does not stop at the desired station,
change to the Manual tuning method as described below.
* STEREO indicator will light up when an FM stereo
broadcast with sufficient signal strength is received.
Manual tuning
1 1
Follow steps 1 and 2 of the Automatic tuning method.
2 2
Press the AUTO/MAN'L button so that "AUTO"
disappears from the display.
(In this mode, stations are received in monaural.)
3 3
Press and hold the
frequency, or press and hold the
lower frequency.
Release it just before reaching the desired frequency,
and then press it repeatedly until the desired frequency
appears.
(When tuned in to a station, "TUNED" will light up on the
display.)
Note
If you tune in to an FM station manually, it is received in
monaural automatically to increase the signal quality.
Note
Pressing the TUNER input selector button on the remote
control transmitter switches the tuner from FM to AM mode
and vice versa.
E-26
button to tune to a higher frequency, or
button to tune to a lower frequency.
button to tune to a higher
button to tune to a