Using The Built-In Timer; Setting The Clock; Adjusting The Brightness Of The Display - Yamaha CDX-E100 Owner's Manual

USING THE BUILT-IN TIMER

Setting the clock

You must set the clock before you use the timer functions.
The clock is based on a 24-hour system.
DISPLAY
NATURAL SOUND STEREO RECEIVER RX-E100
DISPLAY MEMORY AUTO/MAN'L
TIME ADJ
STANDBY/ON PHONES
TIME ADJ
1
While the power is on, press DISPLAY to display
the time.
2
While holding TIME ADJ, press HOUR to set the
hour.
• If you want to move the time in the reverse direction,
press HOUR while holding TIME ADJ and PRESET/
BAND.
3
While holding TIME ADJ, press MIN to set the
minutes.
• If you want to move the time in the reverse direction,
press MIN while holding TIME ADJ and PRESET/
BAND.
To display the clock
Press DISPLAY.
The current time appears for about 8 seconds, then the
normal display returns.
Note
• In the event of a power failure or when the AC power cord is
disconnected for more than five minutes, you must reset the
clock.
E-14
HOUR MIN
VOLUME
PRESET/BAND PRESET/TUNING
MIN MAX
TIMER HOUR PTY SELECT MIN INPUT
BASS TREBLE BALANCE
- + - +
L R
PRESET/BAND
Adjusting the brightness
of the display
You can adjust the brightness of the display. If you have
connected the CD player (CDX-E100), cassette deck
(KX-E100), and/or MD recorder (MDX-E100) to this
unit, the brightness of the displays is automatically
adjusted to that of this unit.
DISPLAY
NATURAL SOUND STEREO RECEIVER RX-E100
DISPLAY MEMORY AUTO/MAN'L
TIME ADJ TIMER
STANDBY/ON PHONES
Press and hold DISPLAY for about two seconds so that
"Dimmer ±0" appears on the display. While holding
DISPLAY, turn INPUT clockwise to increase or
counterclockwise to decrease brightness.
Control Range: ±0 to –6 (Preset value: ±0)
VOLUME
PRESET/BAND PRESET/TUNING
MIN MAX
HOUR PTY SELECT MIN INPUT
BASS TREBLE BALANCE
- + - +
L R
INPUT