Installing The Fan Tray From The Front Panel Of The Chassis - Cisco Catalyst 9600 Manual

Installing the Fan Tray

Installing the Fan Tray from the Front Panel of the Chassis

Before you begin
• Read
• Enable the service mode on the chassis, if you are performing this task in a system that is powered on.
• Ensure that you have the following tools and accessories available:
Procedure
Step 1
Hold the fan tray assembly with the fans facing to the right.
Step 2 Place the fan tray into the fan tray slot so it rests on the chassis, and then lift the fan tray up slightly, aligning
the top and bottom guides.
Figure 5: Inserting the Fan Tray from the Front of the Chassis
1
Step 3 Slide the fan tray into the chassis until the two captive installation screws make contact with the chassis.
Step 4
Tighten the two captive installation screws on the front, to secure the fan tray assembly in the chassis.
Guidelines for Removing and Installing a Fan Tray, on page
• Phillips-head screwdriver
• Anti-static mat
Front side of the fan tray
Installing the Fan Tray from the Front Panel of the Chassis
1.
2 Fan tray without the connector
Installing the Fan Tray
9