Cisco Catalyst 9600 Manual page 4

Removing the Fan Tray from the Front of the Chassis
Figure 1: Detaching the Connector from the Fan Tray
1
2
The connector is not used or replaced when installed from the front. The connector can be scrapped or
stored for future use.
c) Place the replacement fan tray on an anti-static mat and within arm's reach.
Step 2
Proceed with removing the fan tray from the chassis. Loosen the two captive installation screws on the front
panel of the fan tray (the side with the fan STATUS LED).
Installing the Fan Tray
4
Captive installation screws on the front of
the fan tray assembly
The connector in the rear, separated from
the fan tray
3 Fan tray
- -
Installing the Fan Tray