Mounting - Motorola SE955 Integration Manual

2 - 2 SE955 Integration Guide

Mounting

There are two mounting holes (M1.6 x 0.35), and two locator holes on the bottom of the chassis (see
2-1). The SE955 can be mounted in any orientation with no degradation in performance.
Top View (SE955-I105R/E105R)
Side View (SE955-I105R/E105R)
Back View (SE955-I105R/E105R)
Notes:
1. Chassis is electrically connected to ground and must
be isolated from Vcc.
2. Mounting screws and locating pins must be
non-magnetic material. Do not place any magnetic
material within 1 inch of the SE955 chassis without
testing.
3. Holes marked 'A' are mounting holes. Holes marked 'B'
are scan engine location aids.
4. This is a reference drawing and is not intended to
specify or guarantee all possible integration requirements
for this engine.
5. Untoleranced dimensions:
.x: ± .5 mm; .xx: ± .25 mm; .xxx: ± .125 mm
Dimensions are mm.
SE955 Mounting Diagram
Figure 2-1
Top View (SE955-I100R/I300R/E100R)
Side View (SE955-I100R/I300R/E100R)
Bottom View (SE955-I100R/I300R/E100R)
Figure