Quick Transfer Of Parameter Settings Between Multiple Frequency Converters - GE Ecomagination AF-600 FP Programming Manual

How to Program
[Off]
[Off] stops the connected motor. The key can be selected
as [1] Enabled or [0] Disabled via parameter K-41 [Off] Button
on Keypad. If no external stop function is selected and the
[Off] key is inactive, the motor can only be stopped by
disconnecting the mains supply.
[Auto]
[Auto] enables the frequency converter to be controlled via
the control terminals and/or serial communication. When a
start signal is applied on the control terminals and/or the
bus, the frequency converter starts. The key can be
selected as [1] Enabled or [0] Disabled via
parameter K-42 [Auto] Button on Keypad.
NOTICE
An active HAND-OFF-AUTO signal via the digital inputs
has higher priority than the control keys [Hand] – [Auto].
[Reset]
Press [Reset] to reset the frequency converter after an
alarm (trip). It can be selected as [1] Enable or [0] Disable
via parameter K-43 [Reset] Button on Keypad.
The parameter shortcut can be carried out by pressing the
[Main Menu] key for 3 s. The parameter shortcut allows
direct access to any parameter.
DET-620D
AF-600 FP™ Programming Guide
2.1.2 Quick Transfer of Parameter Settings
between Multiple Frequency
Converters
Once the set-up of a frequency converter is complete,
store the data in the keypad or on a PC via Drive Control
Tool Software DCT 10.
Illustration 2.13 Keypad
Data storage in keypad
NOTICE
Stop the motor before performing this operation.
To store the data in the LCP:
1.
2.
3.
4.
All parameter settings are now stored in the keypad
indicated by the progress bar. When 100% is reached,
press [OK].
Connect the keypad to another frequency converter and
copy the parameter settings to this frequency converter as
well.
03/2016 All rights reserved.
Go to parameter K-50 Keypad Copy.
Press the [OK] key.
Select [1] All to keypad.
Press the [OK] key.
2 2
15