Calibrating Pointer
Your new bandsaw is equipped with a fence mea-
surement system that includes a fence pointer,
which must be calibrated when the bandsaw is
first set up.
To calibrate pointer:
1.
If fence is mounted on right-hand side of
blade, remove it and re-install it on left-hand
side of blade.
2.
Place fence flush against bandsaw blade
(see Figure 35).
Figure 35. Example of fence flush with blade.
-30-
3.
Loosen pointer adjustment screw (see Figure
36) and set pointer in line with "0" and mea-
surement scale on table.
Figure 36. Location of fence pointer adjustment
screw.
4.
Tighten pointer adjustment nut.
Model G0636X (Mfd. Since 09/18)