Cisco Firepower 4100 Series Manual page 14

40-Gb Network Module with Hardware Bypass
7
40-Gb Network Module with Hardware Bypass
The following figure shows the front panel of the 40-Gb hardware bypass network module
(FPR4K-NM-2X40G-F). The FPR4K-NM-2X40G-F is a single-wide module that does not support hot
swapping. The two ports are numbered left to right. Pair the two ports to create a hardware bypass paired set.
Note Make sure you have the correct firmware package and software version installed to support this network
module. For instructions on how to verify your firmware package version and to upgrade the firmware if
necessary, see the
FXOS Compatibility
Figure 11: FPR4K-NM-2X40G-F
1
Overview
14
Bypass LEDs B1 through B4
• Green—In standby mode.
• Amber, flashing—Port is in hardware bypass
mode, failure event.
• Amber—Port is in hardware bypass mode,
forced.
Cisco Firepower 4100/9300 FXOS Firmware Upgrade
for the software compatibility matrix.
Captive screw/handle
Guide. See Cisco Firepower 4100/9300
Ethernet X/1
2
Ports 1 and 2 are paired together to form a
hardware bypass pair.
Overview