Remove And Replace The Ssd - Cisco Firepower 4100 Series Maintenance And Upgrade Manual

Hide thumbs Also See for Firepower 4100 Series:

Table of Contents

Maintenance and Upgrade

Note

The system supports operation with a single fan failure (N+1 fan redundancy), but do not run the system for

an extended amount of time without all fan modules installed. Keep removal and replacement time at three

minutes. Remove and replace one fan module at a time.

Step 1

To remove a fan module, face the rear of the chassis, and grasp the handle of the fan module.

Step 2

Squeeze the handle to disengage the latches on the left and right of the fan module.

Step 3

Pull the fan module out of the chassis.

Figure 2: Remove the Fan Module

Step 4

To replace a fan module, hold the fan module in front of the fan slot.

Step 5

Push the fan module into the chassis until it is properly seated and the latches snap into place.

If the system is powered on, listen for the fans. You should immediately hear the fans operating. If you do not hear the

fans, make sure the fan module is inserted completely into the chassis and the faceplate is flush with the outside surface

of the chassis.

Step 6

Verify that the fan is operational by checking the fan module LED. See

LEDs.