RCA 54-45 Manual page 19

_.. 1 . ( ) From HOLE "F", connect the THICK GREEN WIRE to R23-2 (S1).
J.
( ) From HOLE "F", connect the THICK BROWN WIRE to R23-3 (S1).
_3. ( ) From HOLE "B", connect the GREEN WIRE to R47 -3 (S1).
( ) From HOLE "B", connect the YELLOW WIRE to R47 -1 (S1) .
�
5. ( ) From the switch cut2!lt, connect the RED WIRE to R12-3 (S1).
-
--s .
( ) From the switch cutout, connect the INNER CONDUCTOR of the BLACK COAXIAL CABLE
to R12-2 (S1). Connect the BRAIDED WIRE to TB12-2 (C).
r7.
( ) From the switch cutout, connect the BLUE WIRE to S3A-11 (S1).
_.8. ( ) Connect a 5" piece of THICK ORANGE WIRE from R21-1 (S1) to TB12-1 (C).
,... .9 .
( ) Connect a 15" piece of THICK VIOLET WIRE to R21-2 (S1). Route the other end along the
chassis, as shown. It will be connected later.
_...-1
0 . ( ) Connect a 7" piece of THICK BLUE WIRE from R21-3 (S1) to TB13-3 (C) .
..rTl .
( ) Connect a 5" piece of THICK BLUE WIRE from R23-1 (S1) to TB13-1 (C).
GENERAL: Before going on with the next figure, please review all of the preceding steps pertaining
to Figure 12 for any possible errors.
1. ( ) From HOLE "H", connect the BLACK/WHITE COTTON COVERED WIRE of the TWISTED
BLACK/WHITE and BLACK pair to R23-4 (S1) and the BLACK COTTON COVERED WIRE to
R23-5 (S1).
- 2. ( ) Cut both leads on a 100 uufd DISC CAPACITOR, C17, to 3/4". CONNECT from S3A-3 (S1)
to TB13-2 (C).
-3. ( ) Cut both leads on a . 002 ufd DISC CAPACITOR, C18, to 1". CONNECT from S3A-2 (S1) to
TB13-2 (C).
4. ( ) Cut both leads on a . 022 ufd, 200V MYLAR CAPACITOR , C19, to 1". CONNECT from
-
S3A-1 (S1) to TB13-2 (C). ·
_-5.
( ) Cut both leads on a 330KO, 1/2W, 10 % (orange, orange, yellow, silver) RESISTOR, R48,
to 1". CONNECT from R47-2 (S1) to TB13-2 (S4).
FIGURE 12
FIGURE 13
18
-