RCA 54-45 Manual page 10

( ) Place the threaded portion of the BINDING POST through the double "D" hole in the
b.
PLASTIC PLATFORM.
c. ( ) Secure the assembly from the rear of the panel using the hardware supplied in the
following order: one No. 8 flalwasher, one No. 8 splitwasher, one No. 8-32 hex nut, one
No. 8 brass lug, and one No. 8-32 hex nut.
GENERAL: Before going on with thE next figure, please review all of the preceding steps pertaining
to Figure 3 for any possible errors.
GENERAL: Unless otherwise indicated, all wire used is the type with THIN colored insulation.
�-
( ) Connect a 4" piece of BROWN WIRE from XV1-4 (S1
�- ( ) Connect a 2-1/2" piece of YELLOW WIRE from XVl-5 (S
"""' 3 . ( ) Connect a 4-1/2" piece of RED WIRE to TB4-3 (C). ROUTE the other end toward the front
of the chassis as shown. It will be connected later.
\}4 . ( ) Connect a 4" piece of RED WIRE from TB4-2 _ ( C) to TB6-5 (C).
J,-· 5 .
( ) Connect a 3-1/2" piece of ORANGE WIRE from TB3-4
.
J
\76 . ) Connect a 3-1/2" piece of BLUE WIRE from TB3-3 (C) to TB5-3 (C).
�
( ) Connect a 6" piece of GRAY WIRE to TB6-2 (C).
the chassis as shown. It will be connected later.
Vs.
( ) Connect a 4" piece of ORANGE WIRE from T � 6-4 (C) to TB7-2 (C).
IY'9.
( ) Connect a 3" piece of GREEN WIRE from TB6 � 1 (C) to TB10-3 (C
Y'O.
( ) Connect a 3" piece of YELLOW �RE from XV4-! (C) to XV6-4
( ) Connect a 4" piece of ORANGE WIRE to TB7-2 (C). ROUTE the other end through HOLE
/.)1·
"C" to the top of the chassis. It will be connected later.
(
12. ( ) Connect a 4-1/2" piece of VIOLET WIRE to TB7-4 (C). ROUTE the other end through HOLE
"C" to the top of the chassis. It will be connected later.
·
GENERAL : Before going on with the next figure, please review all of the preceding steps pertaining
to Figure 4 for any possible errors.
FIGURE 4
�
XV2-5 (C).
·
(C) to TB5-1 (C).
,
�
OUTE the other end toward the front of
9
�
to XV2-9 (C).