AEG MTH 350 Operation And Installation page 34

Installation
10.2 Installation options
10.2.1 Undersink installation, non-pressurised, with
non-pressurised tap
10.2.2 Appliance installation
» Mount the appliance on the wall.
Note
The wall must have a sufficient load-bearing capac-
ity.
34

» Undo the cover fixing screws by two turns.
» Undo the snap fastener using a screwdriver.
» Remove the appliance cover with the heater towards
the front.
» Using pliers, break out the knock-out for the power
cable in the appliance cover. Correct the contours
with a file if necessary.

