Honda 2007 Acura RL User Manual page 81

2005-08 ACCESSORIES AND EQUIPMENT Navigation System - RL
2. Turn the ignition switch ON (II). Use the navigation display hard buttons as described below:
Make sure the battery is connected then press and hold the three buttons (Menu, Map/Guide, and
Cancel), and keep them pressed for approximately 5 seconds. The display screen will go directly to
the "Select Diagnosis Items" menu shown below.
Fig. 49: Screen Display - Select Diagnosis Items
Courtesy of AMERICAN HONDA MOTOR CO., INC.
3. After the display changes to the Select Diagnosis Items menu, select the item you want to check and
the diagnostic will start. To return to the previous screen, select "RETURN".
Navi System (Link)

Monitor Check

Unit Check

Car Status

F-CAN (System link)

Coverage area

GPS Information

Yaw Rate

Tire Calibrate

Functional Setup

Version

XM (HIP)

FACTORY DIAGNOSTIC SCREEN "IN LINE DIAG"
When a navigation control unit is powered up for the first time at the factory, the "factory diagnosis" screen
(In Line Diag) shows up. Normally the factory performs the steps necessary to verify proper operation and
terminate the "factory diagnostic".
Until the proper confirmation sequence is performed, the screen will show up every time the vehicle is
started.
Map type
2007 Acura RL