Gps Antenna Removal/Installation - Honda 2007 Acura RL User Manual

2005-08 ACCESSORIES AND EQUIPMENT Navigation System - RL
10. Check online for any service publications prescribing patches for the navigation system, and if any
should be applied to the new navigation unit.
NOTE: Simply transferring the DVD from the original navigation unit to the new
navigation unit does not assure the correct software for the vehicle will
be loaded into the new navigation unit. Doing the DVD transfer without
doing software patches may cause the new navigation unit to appear to
be malfunctioning.
11. Enter the new navigation anti-theft code.
12. Park the vehicle outside, and do the GPS initialization (see GPS INITIALIZATION ).
13. Give the new navigation anti-theft code to the client.

GPS ANTENNA REMOVAL/INSTALLATION

1. Remove the rear shelf (see TRIM REMOVAL/INSTALLATION - REAR SHELF AREA ).
2. Remove the trunk trim (see TRIM REMOVAL/INSTALLATION - TRUNK AREA ).
3. Disconnect the GPS antenna connector (A), and remove the bolt (B).
Fig. 99: Identifying GPS Antenna Connector, Bolt And GPS Antenna
Courtesy of AMERICAN HONDA MOTOR CO., INC.
4. Remove the GPS antenna (C).
5. Install the antenna in the reverse order of removal.
NAVIGATION DISPLAY UNIT REMOVAL/INSTALLATION
1. Remove the dashboard upper visor (see FRONT CENTER SPEAKER ).
2. Remove the three screws (A, B), then remove the display unit (C). The forward screw (B) can be seen
through the windshield or with a mirror.
2007 Acura RL