Step 9: Configure Ip-To-Ip Manipulation Rules - NEC SV9100 Configuration Note

Configuration Note
4.9

Step 9: Configure IP-to-IP Manipulation Rules

This step describes how to configure IP-to-IP manipulation rules. These rules manipulate
the source and / or destination number. The manipulation rules use the configured IP
Groups to denote the source and destination of the call. As configured in Section 4.7 on
page 35, IP Group 0 represents IP-PBX, and IP Group 1 represents BroadCloud SIP
Trunk.
Note: Adapt the manipulation table according to you environment dial plan.
For example, for this interoperability test topology, a manipulation was configured to add
the prefix to the destination number for calls from the IP-PBX IP Group to the BroadCloud
SIP Trunk IP Group for specific destination username prefix.

To configure a number manipulation rule:
1. Open the IP-to-IP Outbound Manipulation page (Configuration tab > VoIP menu >
SBC > Manipulations SBC > IP-to-IP Outbound).
2. Click Add.
3. Click the Rule tab, and then configure the parameters as follows:
Index
Name
Source IP Group
Destination IP Group
Destination Username Prefix
Version 7.0
Parameter
51
4. Configuring AudioCodes E-SBC
Value
0
Add + for National Calls
IP-PBX
BroadCloud
001
AudioCodes Mediant E-SBC