Accessing The User Program; 1-Channel Meter - GE DigitalFlow DF868 Startup Manual

Chapter 2. Initial Setup

2.3 Accessing the User Program

To access the User Program, press the
Note: If the security feature is active, enter the password and press
submenu section in Chapter 1 of the Programming Manual for more information on the security feature.

2.3.1 1-Channel Meter

For a 1-Channel Model DF868, the measurement mode screen is replaced by the following initial programming mode
screen:
2.3.2 2-Channel Meter
For a 2-Channel Model DF868, the following two-step sequence is required to reach the initial programming screen:
ACTIV
Only the submenus
information on the other submenus.
Note: In this manual, only the programming of Channel 1 will be described. To program Channel 2, simply repeat the
same procedures presented for Channel 1.
18
[PROG]
key on the keypad.
PROGRAM
PROGRAM
status
ACTIV SYSTM PIPE
PROGRAM
PROGRAM
Channel 1
CH1 CH2 GLOBL
Chan 1 PROGR
Channel PROGRAM
status
ACTIV SYSTM PIPE
SYSTM PIPE
, and are discussed in this manual. Refer to the Programming Manual for
DigitalFlow™ Multipurpose Ultrasonic Liquid Flowmeter Startup Guide (1- and 2-Channel)
[ENT]
Start ‰ At the User Program screen
shown, press
the next page for instructions.
I/O
[F1]
Start ‰ Press or
submenu for Channel 1 or
Channel 2, respectively, from the
option bar.
SAVE
Start ‰
At the User Program screen
shown, press
the next page for instructions.
I/O
to enter the User Program. See the SECUR
[F1]
and proceed to
[F2]
to select the
[F1]
and proceed to