Functions - Breville Mistic 2 in 1 Connect LTF408 Instruction Book

o

Functions

COOLING MODES
Your tower fan has 4 cooling modes:
NORMAL, NATURAL, NIGHT and ECO. The
tower fan will start automatically on NORMAL
mode on speed 5 when the fan is first switched
on or after it is reconnected to a power supply.
1. To choose between these cooling modes,
press the button found on the remote
control only, until the corresponding
symbol illuminates on the LED display
screen. The LED display screen will
illuminate and alternate between the
room ambient temperature and current
fan setting.
2. To change or cancel a cooling mode, press
the button to change the mode, or the
ON/OFF button to stop operation.
n
NOTE:
The tower fan has a memory function and will
return to the same fan speed and mode it was
set at when it was turned off. This will only
occur if the tower fan is not unplugged and/or
switched off at the power point.
The memory function is not available for
humidification mode.
NORMAL MODE
NORMAL mode has 12 fan speed settings;
1 being the lowest, and 12 the highest, with
the default speed at 5. To choose a fan speed
setting, touch the
the control panel or the remote, until the
desired number flashes on the LED display
screen 3 times, then sets.
NORMAL mode is the default mode settings
for this tower fan. In NORMAL mode, no light
illuminates on NATURAL, NIGHT or ECO
on the LED display screen.
LTF408_ANZ_IB_D20.indd 13 LTF408_ANZ_IB_D20.indd 13
and buttons on either
NATURAL MODE
Continuous air flow can create a chilling
effect on the skin and a discomfort when
exposed for too long. NATURAL mode
generates a gentle breeze to maintain body
temperature by simulating wind blowing
rhythm, automatically alternating wind
speeds according to pre-programmed cycles.
NATURAL mode has 4 cycle programs.
Each cycle is made of two low speeds and
two high speeds alternating randomly
within a fluctuating time range.
To choose a cycle program, touch the
buttons on either the control panel or the
remote until the desired number flashes
on the LED display screen for 3 seconds,
then sets.
Cycle Low Speeds
program (10-19 secs)
1 1 & 2
2 5 & 6
3 7 & 8
4 9 & 10
and
High Speeds
(5-14 secs)
3 & 4
7 & 8
9 & 10
11 & 12
13
15/7/20 2:14 pm 15/7/20 2:14 pm