Honda 08B23-SJC-100 Installation Instructions Manual page 14

44. Position template B on the center console at the
location shown, and tape the template to the
center console.
TAPE
CENTER
CONSOLE
45. Using a push-pin, mark the center console at the
marks on the template. Remove the template.
46. While wearing eye protection, drill an 8 mm hole at
each marked point. Start with a 3 mm drill bit and
finish with an 8 mm drill bit holes. Use the drill bit
with the tape attached.
DRILL
DRILL BIT
(3 mm 8 mm)
CENTER
CONSOLE
47. Using a 1-1/8" (28 mm) hole saw, enlarge the
center 8 mm hole to 1-1/8" (28 mm). Remove any
burrs from each hole.
14 of 24
PUSH-PIN
MARKS
(3)
TEMPLATE B
4915080H
HOLE SAW
1-1/8" (28 mm)
HOLE SAW
MARKS
(3)
4915091H
AII 32445 (0605)
48. Reposition the center console in place. Route the
i-VES harness, and DIN cables "A" and "B" through
the 28 mm hole.
DIN
CABLE "B"
CENTER
CONSOLE
49. Plug in the vehicle connectors, and install the
vehicle connector in the vehicle clip. Route the
vehicle console light harness through the console
light opening.
VEHICLE CONSOLE
LIGHT HARNESS
CENTER
CONSOLE
VEHICLE
VEHICLE
CONNECTOR
CLIP
© 2006 American Honda Motor Co., Inc. - All Rights Reserved.
i-VES
HARNESS
DIN
CABLE "A"
28 mm
HOLE
4915101H
CONSOLE
LIGHT
OPENING
CENTER
CONSOLE REAR
COVER