Control Connectors; Pan-Tilt Head, Housing, Lens, And Camera Operation - Canon BU-47H 1AM Operation Manual

4-2. Control connectors

⑩
⑨
① DC-IN
This is an input terminal for DC power supply.
② LED
This is lit when the power is on, and it is not lit when the power is off.
③ START switch
This is the start switch.
④ AUX
This terminal is used to control arbitrary functions. (HR10A-10R-10S (71)/HIROSE)
For the pin assignment, refer to the separate installation manual. This can be used as a
universal contact circuit.
⑤ CONT.
This is an input terminal for the pan-tilt head, lens and camera control signals.
(PRC05-R12M/TAJIMI)
For the pin assignment, refer to the separate installation manual.
⑥ SDI
This is an output terminal for uncompressed digital video and digital audio signals.
⑦ VBS
This is an output terminal for SD composite signals.
⑧ SYNC
This is an input terminal for external sync signals.
⑨ Waterproof connector for MIC
This is the control terminal for the microphone (option).
⑩ Waterproof connector for washer
This is the control terminal for the washer (option).

4-3. Pan-tilt head, housing, lens, and camera operation

The BU-47H main unit and built-in lenses and camera are controlled from the operation unit.
The functions and operating procedures vary depending on the operation unit that is used. For further
information, please refer to the operation manual of your operation unit.
A-A section
A
A
①
E13
② ③ ④
SD I
A UX
START
STOP
V B S
CONT
SYNC
Receptacle unit
⑤
⑥
⑦
⑧