Table of Contents
Advertisement
5. Repeat the previous steps for the opposite side (Fig. 2).
6
4
3
1
9
8
Figure 2
1. Bagger mounting bracket
2. Bolt, 3/8 x 1–1/4 in.
3. Flange nut, 3/8 in.
4. Bracket stiffener
5. Left side bracket
Installing the Bagger Mounting Bracket
onto an Air Cooled Machine
Important
When installing the bagger onto an air
cooled machine, use the air cooled spacer (Fig. 3).
1. Install the bagger mounting bracket to the rear frame of
the machine (Fig. 3).
2. In the top two holes, install 2 bolts (3/8 x 1–3/4 in.),
2 flange nuts (3/8 in.) and the air cooled frame spacer
(Fig. 3).
3. In the bottom two holes, install 2 bolts (3/8 x 1–1/4 in.)
and 2 flange nuts (3/8 in.) (Fig. 3).
5
10
3
7
4
3
6
2
m–5978
6. Bolt, 3/8 x 3/4 in.
7. Long frame spacer
8. Bolt, 3/8 x 1–1/2 in.
9. Short frame spacer
10. Right side bracket
4
5
1
6
2
6
2
Figure 3
1. Bagger mounting bracket
2. Bolt, 3/8 x 1–1/4 in.
3. Flange nut, 3/8 in.
Installing the Bagger Mounting
Bracket onto a Liquid Cooled
Machine
Important
Do not tighten any bolts until both side
brackets and bagger mounting bracket are fit loose on the
machine.
Refer to Tightening the Mounting Bolts, on page 8, for the
correct procedure to tighten the bolts.
Installing the Bagger Mounting Bracket to
the Side Brackets (Liquid Cooled)
Important
When installing the bagger onto a liquid
cooled machine, the rear bumper plate must be removed.
Use 4 long frame spacers for this installation, 2 per each
side (Fig. 4).
1. Install the side brackets to the bagger mounting bracket
(Fig. 4).
2. In the top two holes, install 2 bolts (3/8 x 1–1/2 in.),
2 flange nuts (3/8 in.), 2 long frame spacers, and one
short frame spacer (Fig. 4).
Note: Make sure the long frame spacers are installed as
shown in figure 4.
6
3
3
3
m–5863
4. Bumper
5. Air cooled frame spacer
6. Bolt, 3/8 x 1–3/4 in.
Advertisement
Table of Contents
