Table of Contents
Advertisement
8. Adjust the bagger belt for proper tension. Refer to
Adjusting the Bagger Belt on page 12.
9. Adjust the PTO drive belt. Refer to Adjusting the PTO
Drive Belt on page 12.
10. Install the skid plate (Fig. 14).
5
Figure 16
1. Tensioner spring
2. Eye bolt
3. Bagger tensioner pulley
4. Bagger pulley
Figure 17
1. Drive pulley
2. Bagger tensioner pulley
Adjusting the Bagger Belt
1. Check the belt tension (Fig 18).
2. Measure the gap, at the bagger tensioner pulley,
between the tight and slack side of the belt when the
bagger tensioner pulley and spring are installed
(Fig. 18).
2
1
4
6
3
m–5887
5. Belt
6. Shortest space between
belt strands, 1 in. 1/8 in.
3
2
4
1
m–5773
3. Bagger pulley
4. 1/4 twist
3. There must be a gap of 1 in.
between the belt strands(Fig 18).
4. If the gap is not correct, remove the tensioner spring
from the eyebolt and remove the tension on the PTO
spring loaded idler (Fig 19).
5. Loosen the 4 mounting bolts holding the drive pulley
assembly (Fig 20).
6. If the gap measurement is too small, push the pulley
assembly forward slightly [1/8–3/16 in. (3–5 mm)] from
the original set–up position (Fig 20).
7. If the gap measurement is too large, pull the pulley
assembly rearward slightly [1/8–3/16 in. (3–5 mm)]
from the original set–up position (Fig 20).
8. Tighten the 4 mounting bolts holding the drive pulley
assembly to the machine frame (Fig 20).
9. Install the tensioner spring to the eyebolt and apply the
tension on the PTO spring loaded idler.
10. Measure the bagger belt tension. There must be a gap of
1 in.
1/8 in. (26mm
(Fig 18).
11. Repeat this procedure if a gap of 1 in.
(26mm
3 mm) was not achieved (Fig 18).
5
1. Tensioner spring
2. Eye bolt
3. Bagger tensioner pulley
4. Bagger pulley
Adjusting the PTO Drive Belt
1. Check the belt tension. The center bolt of spring loaded
idler must be between the two alignment holes in left
support plate (Fig 19).
12
1/8 in. (26mm
3 mm)
3 mm) between the belt strands
1/8 in.
2
1
4
6
3
Figure 18
5. Belt
6. Shortest space between
belt strands, 1 in. 1/8 in.
m–5887
Advertisement
Table of Contents
