Table of Contents
Advertisement
9. Tape the template to the engine shroud. Mark the outer
edge of the template. (Fig. 13).
10. Cut the engine shroud at the marked line. This will
prevent damage to the engine shroud while using the
bagger lever (Fig. 13).
Note: Make sure to follow the template outline. Do not
create any sharp corners.
5
4
1
9
2
m–5888
Figure 13
1. Cable guide, bolt, nut and
washer
2. Engine shroud
3. Template
4. Lever
Installing the Bagger Tensioner
Pulley and Belt
1. Remove the four bolts in the skid plate (Fig. 14).
2. Remove the skid plate (Fig. 14). This will make it easier
to install the bagger belt.
6
3
7
8
5. Cable guide
6. Mark on template
7. Template bottom
8. Shroud bottom
9. Cable bolt
11
1
2
Figure 14
1. Bolts
3. Install the bagger tensioner pulley onto the idler arm
with a bolt (3/8 x 2 in.), washer (3/8 in.), and lock nut
(3/8 in.) (Fig. 15).
6
3
2
Figure 15
1. Bolt, 3/8 x 2 in.
2. Idler arm
3. Lock nut, 3/8 in.
4. Install the bagger belt onto the drive pulley (Fig. 17).
5. Route the bagger belt onto the bagger pulley
(Figures 16 and 17).
Note: There should be a 1/4 twist in the belt when it is
installed onto the bagger tensioner pulley
6. Install the spring onto the idler arm (Fig. 16).
7. Install the tensioner spring onto the eyebolt attached to
the bagger (Fig. 16 and 18).
m–5862
2. Skid plate
5
1
4
m–5991
4. Washer, 3/8 in.
5. Bagger tensioner pulley
6. Bagger
Advertisement
Table of Contents
