Installing The Boot And Discharge Tubes - Toro 200 Z Master Series Operator's Manual

Figure 22
1. Front caster weight
2. U–bolt
3. Plate
Installing the Extra Top Weights
To comply with ANSI/OPEI B71.4–1999 Standard, top
weights must be added to the machine. Use the chart below
to determine the top weight requirements.
Top Weight Table
Type of Machine
Air Cooled Machine
Liquid Cooled Machine
The factory ships six top weights to be installed on top of
the caster weights.
1. Determine how many top weights are needed for your
machine. Refer to the top weight table.
2. If 2 top weights are needed, for each side, then install
them on top of the caster weight with a bolt (1/2 x 3 in.)
(Fig. 23).
3. If 3 top weights are needed, for each side, then install
them on top of the caster weight with a bolt (1/2 x4 in.)
(Fig. 23).
2
1
3 1
6
4
5
m–5882
4. Nut
5. Front caster
6. Lock washer
Total Size of Bolt
Number of Needed
Top
Weights
6 (3 for 1/2 x 4 in.
each side)
4 (2 for 1/2 x 3 in.
each side)
2
1. Top weight
2. Bolt
Installing the Boot and
Discharge Tubes
Note: Remember to replace the L or the straight end of the
spring when in side discharge mode. Refer to Replacing the
Grass Deflector Spring on page 17.
1. Disengage the PTO and set the parking brake.
2. Stop the engine, remove the key, and wait for all
moving parts to stop before leaving the operating
position.
3. To relieve the spring tension on the grass deflector,
place the L or the straight end of the spring in front of
the mounting bracket (Fig. 28).
4. Lift the grass deflector all the way back. This will
eliminate interference with the boot.
5. Position the boot's front hook into the front slot on the
mounting bracket (Fig. 24).
6. Place the rear hook over the rear of the mounting
bracket (Fig. 24).
7. Install the upper tube into the bagger (Fig. 24).
8. Slide the clamp onto the middle tube (Fig. 24).
9. Align the knob on the middle tube with the notch in the
upper tube. Slide the middle tube into the upper tube
and twist the middle tube 60 degrees (Fig. 24).
10. Tighten the clamp around the upper and middle tube
connection (Fig. 24).
14
1
3
4
Figure 23
3. Front caster weight
4. Front caster wheel
m–5882