Honeywell Accentic proX2 Mounting And Operating Instructions page 27

Mounting and Operating Instructions - proX2-reader "Accentic" with keypad
Activate adjustment mode:
Activate adjustment mode:
a) In the "stand alone" programming mode (see
Chapter 7) or
b) In NetEdit (only when the reader is operated via
RS-485 at the ACS-8 from V06.xx upwards).
The activated adjustment mode is indicated at the
reader by the bottom green LED that flashes briefly
twice followed by a long pause.
LED indicator during the setting process:
The flashing rhythm of the green LED indicates
whether transmission is safe at many (a), a few (b)
or only at one (c) of the 16 possible power stages.
This is an indication of how much power is still
available up to the maximum possible distance.
If the transponder reaches the
range , the green LED only flashes once (c). The
yellow LED flashes additionally and signalizes that
a greater distance cannot be exceeded.
Important:
During adjustment, hold the transponder steadily in the reading range. We recommend
using a non-metallic object as a "spacer" between the reader and the transponder.
Adjust:
- Hold a transponder at the desired distance to the
- As soon as the transponder is identified,
begins to flash.
- Adjustment begins LED indicator see above)
- After approx. 5 sec. adjustment is completed.
Acknowledgement:
- Brief acoustic signal
- The adjustment indicator goes off
- The adjusted distance ist stores and indicated.
- Remove transponder.
After a dead time of approx. 3 sec. the adjustment mode indicator " "
flashes again.
Repeat adjustment
Adjustment can be repeated at any time.
Condition: The adjustment mode must be activated, the adjustment mode display must flash.
Adjust as described above.
Deactivate adjustment mode
The adjustment mode is deactivated via the programming or in the "stand alone" programming
mode (see Chapter 7.) depending on the type of activation.
maximum possible
(
.
F
a)
b)
c)
F
reader .
top green LED
Activate
adjustment mode
i
Transponder identification
Maximum range
Adjustment mode
i
ID card
or other
transponder
27