Setting Up The Serial Port; Entering The Node Id; Entering The Baud Rate - GE CGA 351 User Manual

www.DataSheet4U.com
December 2004

Setting Up the Serial Port

Entering the Node ID

Entering the Baud Rate

www.DataSheet4U.com
4-26
To set up the serial port, enter the User Program, as described on
page 4-1, and proceed as follows:
Cfg Cal Opt Disp
User
Setup
Lock Menus
POWER ESC
Note: The
[Lock All]
and
User
Contrast
Backlight
Comm
POWER ESC
At the following prompt, choose one of the following numbers as the
Node ID: 16, 32, 48, 64, 80, 96, 112, 128, 144, 160, 176, 192,
208, 224, or 240.
User Node-ID
Node ID
s
16 t
POWER ESC
At the following prompt, choose one of the following values as the
serial port baud rate: 300, 1200, 2400, 9600, 19200, 38400,
57600, or 115200.
User Node..Baud-Rate
300
1200
2400
POWER ESC
Use the [ ] and [ ] keys to
[Opt]
select . Then, Use the [ ]
and [ ] keys to select
[ENTER]
and press
ENTER
[Versions]
options are also available.
Use the [ ] and [ ] keys to
[Comm]
select
[ENTER]
.
Note: The
[Analog Output]
also available in this list box.
ENTER
Use the [ ] and [ ] keys to
scroll the list of available node
ID numbers. When the desired
number is highlighted, press
[ENTER]
.
ENTER
Use the [ ] and [ ] keys to
scroll the list of available baud
rates. When the desired rate is
highlighted, press
ENTER
[User]
.
and press
[Fault Alarm]
and
options are
[ENTER]
.
Setup and Calibration