Reset The Tablet To Factory Default State; Repairs; Maintenance - Honeywell RT10W User Manual

Reset the Tablet to Factory Default State

The RT10W tablet has a dedicated recovery partition stored on the hard drive of the
tablet to enable quick one-key recovery process. This partition occupies about
11GB of the storage space.
Caution: Before starting the recovery process, be sure to back up all user
To enable quick one-key recovery procedure and initiate the Recovery Wizard:
1. Plug the AC adapter into the RT10W. Make sure the tablet stays plugged into a
2. Power on the RT10W.
3. When the Honeywell splash screen displays, press and release the Fn1 button
4. Tap Recovery.
5. Tap Yes.
6. Once the recovery process completes:

Repairs

Repairs and/or upgrades are not to be performed on this product. These services
are to be performed only by an authorized service center (see
page v).

Maintenance

Your device provides reliable and efficient operation with a minimum of care.
Although specific maintenance is not required, the following section describes
periodic checks to ensure dependable operation.
RT10W Rugged Tablet
data, as all personal files will be lost after the recovery process.
power source during the recovery process.
to start the Recovery Wizard or, if using an external USB keyboard, press F6.
A command prompt displays the progress of the recovery message. This
process make take several minutes.
If you do not have an external keyboard, the RT10W will turn off automatically
after a few minutes.
If you have an external keyboard attached, press any key to continue when
prompted, and the RT10W will turn off.
Customer Support on
55