Honeywell RT10W User Manual page 45

Manual
1. Select Bluetooth Scanning from the Control Panel (either large or small icon
2. Tap Add Device.
3. Select Manual.
4. Tap Next.
5. Enter the MAC address of the Bluetooth scanner.
6. Tap Next.
Troubleshooting
•
•
•
•
•
•
•
Adding Other Scanners
Some scanners may not be supported/discoverable by Bluetooth Scanning. In this
case, use the Microsoft Bluetooth panels to add the scanner.
Note: The Microsoft Bluetooth panels should only be used when the scanner cannot be
connected with one of the methods listed above.
RT10W Rugged Tablet
view option must be selected).
The Honeywell Xenon 1902 Bluetooth scanner does not work with Quick
Connect. It must be connected using the Search or Manual options.
Make sure the scanner is in the correct mode. Barcodes to set the mode can be
found in the manual provided with the Bluetooth scanner.
• The scanner must be a master device to use the Quick Connect option.
• The scanner must be a slave device to use the Search or Manual option.
The Motorola/Symbol LS3578 family of scanners may not support the Quick
Connect feature (depending on firmware installed). If Quick Connect does not
work, use the other options to connect these scanners.
If the Honeywell Granit 1911i and Granit 1981i scanners cannot be found with
the Search option, scan the PDAs/Mobility Systems Devices barcode from the
scanner manual and search again.
If the Honeywell Granit 1911i and Granit 1981i scanners cannot connect using
the manual option, scan the PDAs/Mobility Systems Devices barcode from the
scanner manual then repeat the manual add process again.
If the Honeywell Granit 1911i and Granit 1981i scanners are not removed after
using the Remove option, the auto-reconnect option is enabled on the Granit
scanner (this is the default option). To remove the scanner:
• Scan the disable auto-reconnect barcode from the Granit scanner manual
then tap Remove, or
• Scan BT_RMV to unlink and disconnect the scanner the tap Remove.
If a Honeywell/LXE ring scanner is not connecting, scan the Restore Factory
Defaults barcode in the scanner manual and try connecting again.
37