Cisco ASR 920-24SZ-IM Installing page 15

Table of Contents

Installing the Router

Installing the Interface Module

Note

Before installing the interface module, read the Activating or Deactivating Interface Module section in the

Cisco ASR 920 Series Aggregation Services Router Configuration

Procedure

Step 1

Before inserting an interface module, make sure that the chassis is grounded.

Step 2

If present, remove the blank filler plate covering the interface module slot. To remove, pull the blank filler

plate completely out of the router slot using the captive screws.

Step 3

To insert the interface module, carefully align the edges of the interface module between the upper and lower

edges of the interface module slot in the router.

Step 4

Carefully slide the interface module into the router slot until the interface module makes contact with the

backplane. The following figure shows how to install the interface module on Cisco ASR-920-24SZ-IM

Router.

Figure 14: Inserting an Interface Module on Cisco ASR-920-24SZ-IM Router

Installing the Interface Module

Guide.

Installing the Router

Table of Contents

Asr-920-24sz-m Asr-920-24tz-m