Removing A Dimm - Cisco 5100 Series Hardware Installation Manual

Removing a DIMM

Figure 13: Inserting a DIMM
Step 6
Replace the chassis cover.
Removing a DIMM
These are the steps to remove a DIMM:
Step 1
Remove the chassis cover.
Step 2 Locate the DIMM module on the device. Refer to the
DIMM module.
Step 3 Pull the latches away from the DIMM at both ends to lift the DIMM slightly. Pull the DIMM out of the socket.
Figure 14: Removing a DIMM
Step 4
Place the DIMM in an antistatic bag to protect it from ESD damage.
Step 5 Replace the chassis cover.
Cisco 5100 Enterprise Network Compute System Hardware Installation Guide
24
Installing and Upgrading Field Replaceable Units
Chassis - Internal, on page 2 section to identify and locate the