Cisco 5100 Series Hardware Installation Manual page 14

Enterprise network compute system

Hide thumbs Also See for 5100 Series:

Table of Contents

SFP Modules

Part Number

GLC-SX-MMD

SFP-GE-S

1 A mode-conditioning patch cord, as specified by the IEEE standard, is required. Using an ordinary patch cord with MMF, 1000BASE-LX/LH

SFP transceivers, and a short link distance can cause transceiver saturation, resulting in an elevated bit error rate (BER). When using the LX/LH

SFP transceiver with 62.5-micron diameter MMF, you must also install a mode-conditioning patch cord between the SFP transceiver and the

MMF cable on both the sending and receiving ends of the link. The mode-conditioning patch cord is required for link distances greater than 984

feet (300 m).

Cisco 5100 Enterprise Network Compute System Hardware Installation Guide

Overview of the Cisco 5100 Enterprise Network Compute System

Description

Cisco 1000BASE-SX SFP module for MMF, 850-nm

wavelength, extended operating temperature range.

Cisco 1000BASE-SX SFP module for MMF, 850-nm

wavelength, extended operating temperature range.

Table of Contents