Honda 08B23-S0X-100 Installation Instructions Manual page 6

15. Peel up the door opening trim, and remove the
passenger's kick panel (one plastic screw and
one clip).
CLIP
16. On the passenger's side of the vehicle, remove
the sliding door sill trim (lift up to release the five
clips).
CLIPS
(5)
6 of 15
PLASTIC SCREW
PASSENGER'S
KICK PANEL
PASSENGER'S
DOOR OPENING
TRIM
PASSENGER'S SLIDING
DOOR SILL TRIM
17. Remove the passenger's side center pillar lower
trim panel:
• Remove the front door opening trim and the
sliding door opening trim around the center
pillar lower trim panel.
• Slide the lower anchor cover upward, and
remove the front seat belt lower anchor bolt.
• Gently spread open the top of the center pillar
lower trim panel to release the two retaining
tabs, then release the three clips, and remove
the lower trim panel. Take care not to damage
the clips and retaining tabs.
FRONT
DOOR
OPENING
TRIM
CENTER PILLAR
LOWER TRIM
PANEL
AII 26017 (0308)
SLIDING DOOR
OPENING TRIM
FRONT SEAT BELT
LOWER ANCHOR BOLT
(Note the sequence of
washers. Tape the
washers together to
prevent them from
being disrupted.)
© 2003 American Honda Motor Co., Inc - All Rights Reserved.
RETAINING
TAB
CLIP
LOWER
ANCHOR
COVER